![]() IP address: IP address of a host device behind the gateway. Port: For TCP protocol, specify the port number to use for health check probes. Protocol: Protocol for checking the gateway’s status. Specify the following settings for monitoring the gateway: If the hosts respond to health check probes, Sophos Firewall considers the gateway active. Sophos Firewall sends requests to host IP addresses behind the gateway. If the gateway doesn't respond to these attempts, Sophos Firewall considers the gateway unreachable. The number of consecutive attempts to probe the gateway's health. The gateway must respond within this time to be considered active. Time interval between probes for the health check. Turn it on to perform health checks for monitoring the gateway status. Sophos Firewall prioritizes the gateway zone over the interface zone. The default gateway is set to the WAN zone. Select the zone to assign to the gateway. Go to Routing > Gateways, and click Add.You can apply more than one monitoring condition for health checks. Specify the health check settings to determine if the gateway is active. For example, you can route traffic to servers based on their zone. Migrate to another authenticator applicationĬreate a custom gateway and specify health checks to determine if the gateway is active.Īssign a zone to custom gateways if you want to route traffic based on the network host's zone.Check connectivity between an endpoint device and authentication server using STAS.Configure the user inactivity timer for STAS.How to see the log for Sophos Transparent Authentication Suite (STAS).Allow clientless SSO (STAS) authentication over a VPN.Configure a Novell eDirectory compatible STAS.Synchronize configurations between two STAS installations.Configure transparent authentication using STAS.Group membership behavior with Active Directory.Route system-generated authentication queries through an IPsec tunnel.Configure Active Directory authentication.Sophos Connect client Sophos Connect client.SSL VPN (remote access) SSL VPN (remote access).IPsec remote access group authentication.IPsec (remote access) IPsec (remote access).Create an L2TP remote access connection.Create a remote access SSL VPN with the legacy client.Configure remote access SSL VPN with Sophos Connect client. ![]() Configure IPsec remote access VPN with Sophos Connect client.SSL VPN (site-to-site) SSL VPN (site-to-site).Comparing policy-based and route-based VPNs.Use NAT rules in an existing IPsec tunnel to connect a remote network.Configuring NAT over a Site-to-Site IPsec VPN connection.IPsec VPN with firewall behind a router.Add a POP-IMAP scan policy (legacy mode).Policies and exceptions Policies and exceptions.Protect internal mail server in legacy mode.Configure the quarantine digest (MTA mode).Set up Microsoft Office 365 with Sophos Firewall.Configure protection for cloud-hosted mail server. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |